(a) The minimum width of lots at the building line in subdivisions shall be 50 feet.

(b) The minimum depth of lots in subdivisions shall be 110 feet.

(c) The minimum area of lots shall be subject to the district zoning regulations in which the subdivision is located.

(d) All side lot lines shall be at right angles to straight street lines, or radial to curved street lines in subdivisions.

(e) All corner lots in subdivisions shall have a minimum building setback of 30 feet to both streets, unless certain conditions such as topography, street alignment or adjacent setbacks warrant a deviation in this requirement.

(f) Double frontage lots in a subdivision shall be avoided unless, in the opinion of the Planning Commission, variation to this rule will give better street alignment and lot arrangement.

(g) Every lot in a subdivision shall have a frontage upon a street.

(h) Building or setback lines shall be shown on the preliminary and final plat only when determined to be necessary by the Planning Director due to unusual lot design, configuration, or special circumstances where setback lines need to be delineated to specify the appropriate setback.

(i) In subdivisions where a septic tank or other individual sewage disposal devices are to be installed, the size of all lots included in the subdivision shall be subject to regulations in TMC 18.40.030.

(j) In subdivisions served by private water supply, well or other means, the size of all lots included in the subdivision shall be subject to regulations in TMC 18.30.020 and 18.40.020(c). (Ord. 18266 § 3, 6-15-04. Code 1981 § 41-99. Code 1995 § 134-141.)